Hi can someone point me in the right direction or tell me what the correct pinouts are for the USB pin header Please

I don’t have a Fin with me, but I’ve found the following in the datasheet , section 3, item 35: 35, USB 2.0 4-pin header, Exposes a USB 2.0 port via male headers. pin1 is marked in silkscreen with a triangle Does this information go in the right direction? (Is there a triangle on the board?) (On…

Hi I found that too but no Triangle? also I need to know all pins Thanks

Hi @alinnz you are correct that the pin 1 is not properly marked as the datasheet suggests, I will make sure it is updated. Regarding your question, pin 1 is the one closest to the coprocessor and the pinout follows the standard USB pinout, which is as follow: 1 -> Vcc 2 -> D- 3 -> D+ 4 -> GND …

Nico, I am looking for the specs on this USB pin out. I would like know if it is a third USB port? Could I connect a cable and connector to it if? so is it in the /dev list? Paul

Hello @asawizard , Correct that’s another USB port just like the other USB type-A ports. It’s actually a fourth USB port, there’re two type-A ports, the USB header and the USB interface on the mPCIe connector. Cheers, Nico

@asawizard We use something like this to connect a 3rd wifi adapter to it on some deployed devices. Hope that helps! -Thomas

Nico, I have a mPCIe USB device plugged into the fin 1.1.1 but I’m not getting any power. Is there a GPIO command to power cycle the mPCIe port?

USB Pin Header pinout?

balenaFin

anujdeshpande April 9, 2021, 6:24am 20

@semireg

Let’s continue this on the other thread that you have replied to instead of this - balenaFin Crucial M500 120GB mSATA SSD

Topic		Replies	Views
GPIO pin out for the co-processor 20pin header balenaFin gpio	8	1289	April 3, 2019
BalenaFin uart pins balenaFin	14	2765	December 14, 2020
Phoenix ring HAT board balenaFin	21	1444	April 6, 2020
Power pins during CM3 power off balenaFin	4	503	May 29, 2019
Did I fry my Pi? balenaFin	47	1476	November 10, 2022

USB Pin Header pinout?

Related topics