Balena etcher does not show status, expected duration or finished/completion status
Which version of Etcher are you using? What happens when you start the flashing process? Do you get any feedback that the process has started? Perhaps post a screen shot if that would help demonstrate.
Build for UBUNTU 25-4 encountered problems
These were resolved by using
16 Gb USB stick rather than 8Gb
NOT using the USB Hub/port expand to hold target USB Sick
using a dedicated singular port
using (Admin mode) ‘balenaETCHER -2.1.4.Setup 17/8/25 ’ software
and it validation pass
this allowed blow of 10 + 10 minutes with valeidation